Correlating Filament Dryer Settings to Numerical Values

The goal of this experiment is to correlate the setting labels on the EnCuerdas single-spool filament dryer to actual numerical temperature values.

Procedure

  1. Fix thermocouple about 3cm into filament dryer through front filament hole. Use tape to secure.
  2. Remove filament from dryer.
  3. Repeat for each setting:
    1. Adjust temperature in predefined increments (the borders between settings) and wait for temperature to stabilize.
    2. Record stabilized temperature.

      Equipment

      • EnCuerdas single-spool filament dryer - Model #: Easdry 2305 120V
      • AstroAI multimeter - Model #: DM6000AR - Temperature not calibrated.
      • Standard AstroAI thermocouple
      • 3M Painter’s Tape

        Setup

        ![[IMG_2908.jpeg]] ![[IMG_2909.jpeg]] ![[IMG_2911.jpeg]]

        Results

Setting T (C)
Ambient 20
0 39
1 45
2 48
3 53
4 60
5 66
6 72
7 76

Conclusion

I sharpie’d on the temperature readings in their appropriate spots. Now, I’ll be able to dry at higher temps without fear of melting any filament.

results matching ""

    No results matching ""